Engineer Training Flash Cards
ABTH Only
GCOR Only
Random Question
Weekday Study

Any question, rule number, or answer reported as wrong will get looked at manually in a couple of days. Please write what is wrong with this flash card and what it should be which will speed up the correction process.
-Thank you!

What is wrong:

No Pending Requests Have Been Submited
Front #121

ABTH 102.6

Place in order the steps to reduce pressure in an overcharged air brake system:

  1. Move the automatic brake valve handle to Release.
  2. Adjust the regulating valve to the desired pressure.
  3. Wait at least 30 seconds after the brake pipe exhaust stops.
  4. Make a full-service brake pipe reduction with the automatic brake.
  5. Charge the system to the required pressure.
Back #121
Flag

ABTH 102.6


Answer: 1. Adjust the regulating valve to the desired pressure. 2. Make a full-service brake pipe reduction with the automatic brake. 3. Wait at least 30 seconds after the brake pipe exhaust stops. 4. Move the automatic brake valve handle to Release. 5. Charge the system to the required pressure.
Feedback:
On some older locomotives, the regulating valve knob is located on the control stand. On newer locomotives, it can be accessed on the display screen. The brake system should be set to 90 psi. If it is higher than 90 psi, you must perform these steps.